Avitech Rainier-4d Uživatelský manuál stáhnout pdf (Strana 40)

IMPORTANT: When cascading two or more modules (up to eight maximum) make sure

each module gets assigned a unique rotary ID or it will cause input conflicts.

2. To display video overlay from each module all units must be connected to

each other via male-to-male short DVI cascading cable. Take a DVI

cascading cable and connect one end to the OUTPUT-1 / -2 port on the Master

(first) module (N) and the other end to the CASCADE IN-1 / -2 port of the next

module in the chain (N+1).

3. The Rainier 3G is cascaded through RJ-45 (RS-485) which is used to loop

communication from one Rainier 3G to the next. The data stream carries

control and configuration information. Take the RS-485 cascading cable and

connect one end to the RS-485 OUT of the Master (first) Rainier 3G (N) and

the other end to RS-485 IN of the next Rainier 3G up (N+1). Refer to the

sample combination as follows:

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 186 187

Žádné komentáře

Avitech Rainier-4d Uživatelský manuál Strana 40